shipman 28 sailboat

Review of Shipman 28

Basic specs..

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.

The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats. The boat is equipped with 2 cabins, 5 berths, a galley, 75.0 liter fresh water capacity and toilet facility.

The Shipman 28 is equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.

The Shipman 28 is equipped with a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.

The keel is made of iron. Many people prefer lead keel in favour of iron. The main argument is that lead is much heavier than iron and a lead keel can therefore be made smaller which again result in less wet surface, i.e. less drag. In fact iron is quite heavy, just 30% less heavy than lead, so the advantage of a lead keel is often overstated. As the surface of a fin type keel is just a fraction of the total wet surface, the difference between an iron keel and a lead keel can in reality be ignored for cruising yachts.

The boat can enter most marinas as the draft is just about 1.55 - 1.65 meter (5.09 - 5.39 ft) dependent on the load. See immersion rate below.

The Shipman 28 has been equipped with different engine alternatives.

Alternative 1:

Shipman 28 may be equipped with an inboard Yanmar YSE8 diesel engine

The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.

Alternative 2:

The boat may be equipped with an inboard Farymann diesel engine at 12 hp (8 kW). Calculated max speed is about 4.6 knots

The fuel tank has a capacity of 25.0 liters (6 US gallons, 5 imperial gallons).

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

What is Capsize Screening Formula (CSF)?

The capsize screening value for Shipman 28 is 1.82, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 6.1 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Shipman 28 is about 111 kg/cm, alternatively 624 lbs/inch. Meaning: if you load 111 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 624 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

What is Motion Comfort Ratio (MCR)?

What is L/B (Length Beam Ratio)?

What is a Ballast Ratio?

What is Displacement Length Ratio?

What is SA/D (Sail Area Displacement ratio)?

What is Relative Speed Performance?

Maintenance

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 20m 2 (215 ft 2 ). Based on this, your favourite maritime shop can tell you the quantity you need.

Are your sails worn out? You might find your next sail here: Sails for Sale

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

We are always looking for new photos. If you can contribute with photos for Shipman 28 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us . Criticism helps us to improve.